22 PC Setup Program
298
22.7 Connection to device
This chapter describes the various ways to establish a connection between the
JUMO PC setup program and the device. A connection is possible via:
• LAN interface (HTTP or HTTP proxy)
• USB interface
An existing connection is a requirement for data transfer between the JUMO PC
setup program and system. In the menu bar, open:
Data transfer > Establish Connection ...
22.7.1 Device connections list
The device connections list contains all devices for which a connection has been
configured. The user can add connections to new devices, change the proper-
ties of existing connections (interface parameters) as well as remove connec-
tions.
Connection settings assistant
The "Use connection settings assistant" function assists the user with creating
a new entry, i.e. a new connection, and with editing existing entries. The assis-
tant is always active after opening the device connections list (check mark set).
It is started whenever a new entry is to be added to the device connection list.
Chapter 22.7.2 "Configuring the connection with the assistant", page 300
The assistant can be deactivated by removing the check mark. If a new entry is
to be added to the device connections list then, the user must select the individ-
ual configuration steps on their own. If the device connections list is reopened,
the assistant will again be active.
Chapter 22.7.3 "Configuring the connection without the assistant", page 307
Establishing a connection
If the user wishes to establish a connection (or start date data transfer when
NOTE
The USB interface is not intended for a permanent connection, since uninten-
tional removal of the USB connector cannot be prevented due to the lack of a
captive connection.
To Next Page
Loading...
