307
22 PC Setup Program
22.7.3 Configuring the connection without the assistant
The assistant can be deactivated in the device connections list (remove the
checkmark).
⇨Chapter 22.7.1 "Device connections list", page 298
During configuration, the user is not guided to the next step - as with an active
assistant - but instead must select the individual steps of the configuration on
their own. The following example shows the basic procedure. The parameters
in the individual setup dialogs are largely the same as when configuring with an
assistant so that a description is not provided here. However, additional proto-
cols and interfaces are available for the settings used to establish communica-
tion.
NOTE
Configuring a new connection "without the assistant" requires expert knowl-
edge and is provided only for service purposes.
Step Action
(1) Make the settings for the new device and click
on "Interface
(2) Make the login settings and click
on "Properties"
To Next Page
Loading...
