22 PC Setup Program
312
After you have selected the desired device and clicked the "Next" button, the
graphical overview showing the installed option boards opens. If "User-defined
settings" was selected, the option boards installed can be manually specified for
the setup file here. In this case, use drag and drop to select the desired option
board symbols from the menu bar above and place them on the intended expan-
sion slots marked in green. The expansion slots available for installation are
marked in green while dragging. If "Automatic detection" was selected, the
menu bar with option board symbols is not available; instead, the actual config-
uration of the device read is displayed.
Clicking on the "Next" button opens a dialog window where you can activate ex-
tra codes for the setup file:
• Math/Logic
• Recording
• Digital sensors
Activate the extra codes that you wish to configure in the setup file. When you
wish to transfer the created setup file to a device, you must activate the selected
extra codes for this device.
⇨ Chapter 22.10.4 "Approval of extra codes", page 358
To Next Page
Loading...
