327
22 PC Setup Program
22.8.9 Customer-specific linearization
Value tables and formula for customer-specific linearization must be created
with the JUMO PC setup program. During data transfer to the device, the linear-
ization is then loaded into the JUMO AQUIS touch P together with the setup. Af-
ter the linearizations have been loaded into the device, they can be used when
configuring the following types of analog inputs:
• Universal inputs with a standard signal
(except pH/T-compensated chlorine measurement)
⇨ Chapter 10.5.2 "Universal inputs of base unit and optional boards", page
141
• Temperature inputs for RTD temperatures probes with a customer-specific
characteristic curve (up to 400 Ω, 4000 Ω or 100 kΩ)
⇨ Chapter 10.5.1 "Base unit temperature inputs", page 139
• Analysis measuring inputs for electrolytic conductivity
⇨ Chapter 10.5.8 "CR/Ci measuring ranges", page 150
Open Settings:
Only Setup > Customer-Specific Linearization > Tabs 1 to 8
To Next Page
Loading...
