JUMO AQUIS touch P - Online Parameters; Date and Time; Screenshot

22 PC Setup Program
356
22.10 Online parameters
To set online parameters in the device, the software accesses the device mem-
ory directly. The device must thus be connected via a USB or Ethernet port to
the PC on which the JUMO PC setup program is installed, and a connection be-
tween the JUMO PC setup program and device must be established.
⇨ "Configuring and parameterizing", page 313
22.10.1 Date and time
Here, the current date and the current time in the device are obtained from the
JUMO PC setup program.
Open Settings:
Online Parameters > Date and Time (double-click)
22.10.2 Screenshot
This function can be used to transfer the current display on the device to the PC.
(1) "Read Continuously" button
Starts continuous synchronization of the date / time in the software
with the device
(2) "Stop" button
Stops continuous synchronization of the date / time in the software
with the device
(3) "Synchronize" button
Synchronizes the device time with the time set in the PC setup pro-
gram
The time in the device is matched to the set time as long as the differ-
ence is not more than 30 s. This function is used primarily to synchro-
nize the PC time with the device time.
(4) "Set" button
Sets the time in the device to match the setting in the PC setup pro-
gram
(5) Time setting
The PC time can be used or a time may be entered. The specified time
is set in the device by clicking the "Synchronize" or "Set" button.
(1)
(2)
(3)
(5)
(4)