22 PC Setup Program
358
22.10.4 Approval of extra codes
This function allows the customer to enable extra codes in the device software
(recording function, math, and logic module). After purchasing an extra code in
the device software, you must generate a code number with the aid of the PC
setup program. This is needed by JUMO to generate an individual activation
code that you as a customer need to enable the desired device functions. After
opening "Enable extra codes", you have 3 options available:
• Generate code number
If you wish to purchase an extra code in the device software, you must gen-
erate a device- and option-specific code number and send it to JUMO. After
it receives this code number, JUMO provides you with the activation code
with which you can enable the desired option.
• Enter activation code
After you have sent the code number for the desired extra code to JUMO,
you receive the activation code for this option. Following correct entry of the
activation code, this option is available for use in the device.
• Reset the extra codes
All software-based extra codes in your device can be deactivated
with this option.
Open "Enable Extra Codes":
Online Parameters > Enable Extra Codes (double-click)
22.10.5 Deleting internal measurement data
Upon executing this function, data are deleted completely and permanently
from the measurement memory of the data monitor and recording function. Fol-
lowing this, recording of measurement data is started anew.
Delete internal measurement data:
Online Parameters > Delete Internal Measurement Data (double-click)
To Next Page
Loading...
