JUMO AQUIS touch P - Galvanic Isolation

39
6 Electrical connection
6.3 Galvanic isolation
.
Optional boards for binary outputs:
Relay for 2-way normally open contact,
1-way changeover contact
OUT 6 to OUT 13
Optional boards for binary outputs:
Solid state relay triac
OUT 6 to OUT 13
Optional boards for analog outputs:
0/4 to 20 mA or 0 to 10 V
OUT 6 to OUT 13
Optional boards for binary outputs:
Logic output 0/22 V
OUT 6 to OUT 13
Optional boards for binary outputs:
Solid state relay PhotoMOS
®
OUT 6 to OUT 19
Binary outputs
Relay, power supply unit board
OUT 1 to OUT 2
Analog input 0/4 to 20 mA, base unit
IN 6
Analog outputs, base unit
OUT 4
Binary inputs, base unit
IN 1 to IN 3
Temperature input 1 on base unit
IN 4
Temperature input 2 on base unit
IN 5
USB host interface, base unit
USB device interface, base unit
RS485 base unit
COM 1
Optional boards: Ethernet / PROFINET IO
COM 2
Optional boards for analysis inputs:
IN 7 to IN 8
Optional boards for universal inputs:
IN 11 to IN 12
Optional board: RS485/RS422, PROFIBUS-DP
COM 2
Optional boards: 3-way binary inputs
IN 13 to IN 18
Optional boards
Base unit and
Power supply unit board
Optional boards for voltage supply
outputs DC 24 V and DC ±5 V:
OUT 8/9
Optional boards for binary outputs:
2-way logic output 0/12 V
OUT 6 to OUT 13
AC 30 V
DC 50 V
AC 30 V
DC 50 V
AC 30 V
DC 50 V
AC 30 V
DC 50 V
AC 30 V
DC 50 V
AC 30 V
DC 50 V
AC 30 V
DC 50 V
AC 30 V
DC 50 V
AC 30 V
DC 50 V
AC 30 V
DC 50 V
AC 30 V
DC 50 V
AC 30 V
DC 50 V
AC/DC 3.6 kV
Voltage supply
AC 110 to 240 V; 48 to 63 Hz or
AC/DC 24 V +30/-25 %; 48 to 63 Hz
AC 3.6 kV
AC 3.6 kV
AC 3.6 kV
Note!
If sensors that are not electrically isolated are connected to a digital input
and supplied by an external power source, potential differences between the in-
ternal and external ground can cause problems. Thus, it is preferable to take
power from the power outputs of the JUMO AQUIS touch P.