Step one
Secure unit with safety strap
through top handle and place unit
on a at surface before use. Next,
connect the clamps: Red clamp(+)
to Red terminal(+) and Black clamp
(-) to Black terminal (-).
Step two
Turn the main BIGRIG PRO 16L
Power switch to the ON position
and make sure ignition key is in
rst position. When you get a
Green “8” on the LCD , the cables
are active and you may start your
engine.
Step three
Once you have started your
engine, turn off the BIGRIG PRO
16L, remove the clamps from the
vehicle battery, and store your
BIGRIG PRO 16L unit. Drive safely.
QUICK START GUIDE
Quickstart Guide
To Next Page