Preparations for mounting
Figure7: Mounting
(1) Connection box
(2) Sensor cover
(5) Decor ring
(9) Fastening pins
(10) Screws
￭ Pull off decor ring (5) (see figure 7).
￭ Loosen screws (10) (see figure 7).
Installing the connection box
Figure8: Connection box
(11) Fastening holes
(12) Cable entry, surface-mounted
(13) Thin points for optional cable entries
￭ Align the device (for the position of areas A, B, C, see Aligning the device) –
the brightness sensor should, if possible, be located on the side away from the
window. This reduces the effects of scattered light.
Motion and presence detector
14 / 25
82593233 25.09.2023
J0082593233
To Next Page
Loading...