￭ For an additional flush-mounted cable entry or surface-mounted cable entry,
break out the appropriate thin point (13) (see figure 8).
￭ Fastening the connection box (1) through holes (11) (see figure 8).
Alternatively, the device can also be mounted on a 60mm appliance box. The
screws are not included in the scope of delivery.
Connect device
Figure9: Connection diagram, single device
Figure10: Connection diagram, parallel circuit for expanding the detection field
Max. power cable length 100m. This takes into account all the connecting cables
between the devices and lamps.
Do not connect more than five devices in parallel.
Connect all devices to the same phase conductor.
Set all the devices to the same device function (motion detector or presence de-
tector).
The connection in parallel does not increase maximum connected load.
￭ Connect the sensor cover according to the connection diagram (see figure 9)
or switch the sensor covers according to the circuit diagram (see figure 10).
￭ If multiple circuit breakers supply dangerous voltages to the device or load,
couple the circuit breakers or label them with a warning to ensure tripping.
Motion and presence detector
15 / 25
82593233 25.09.2023
J0082593233
To Next Page
Loading...