Jung DWPMK360WW - Page 18

Ū
Pressing for longer than 10seconds
Switching on the Presence detector
device function
ū
Pressing for longer than 10 seconds
Switching on the Motion detector device
function
Ŭ No function is saved for this device
Test 100 h
Pressing for less than 10seconds
Switch on test operation
Test 100 h
Pressing for longer than 10seconds
On for 100hours
Set 1
Pressing for longer than 10seconds
Save any changes made for later recall
using the
Set 2
button of the supplied IR
remote control
ŭ
Pressing for longer than 10seconds
Switch on/off switch-off warning
Prog Func
No function is saved for this device
Reset
Pressing for between 4 seconds and
10seconds
Switching off the functions: dynamic run-
on time, switch-off prewarning, on for
100hours, test operation
Reset
Pressing for longer than 10seconds
Restoring to factory settings
Switching on a device function
The device can work either as a motion detector or presence detector.
￭ Press the ū or Ū button.
The device works either as a motion detector or presence detector.
When changing the device function, the settings of the previous device func-
tion are saved and reactivated on changing again.
Setting the sensitivity
The sensitivity can be set individually for each PIR sensor.
￭ Press
PIR A
,
PIR B
,
PIR C
or
PIR A-C
button for less than 10 seconds.
￭ Within 5 seconds, press the
25%
,
50%
,
75%
or
100%
button.
Sensitivity is set.
If no touch-sensitive button is pressed within 5seconds, the old setting is kept.
Limiting the detection field
The detection field of the motion detector can be limited by switching off one or two
PIR sensors. Since the detection areas of the PIR sensors overlap, there is no dis-
tinct demarcation of the blocked out detection area. If all the PIR sensors have been
switched off, then the device works as a twilight switch.
￭ Press the
PIR A
,
PIR B
or
PIR C
button for longer than 10 seconds.
Motion and presence detector
18 / 25
82593233 25.09.2023
J0082593233