EasyManua.ls Logo

Jung DWPMK360WW - Page 5

Jung DWPMK360WW
25 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Indoor ceiling mounting, surface-mounted
Product characteristics
2-point light control
Functions settable with IR remote controls
Restriction of the detection field by switching off individual sensors or push-on
cover
Operation with IR remote control, 2-wire extension or push-button
Teach function for adjustment of the brightness threshold, in combination with
IR remote controls
Switch-off warning
Short time operation, e.g. to activate acoustic signal encoders
Display LEDs
Presence simulation
Function as twilight switch
Dynamic run-on time
Extension of the detection field through parallel switching of multiple devices
The extension of the detection field with 3-wire extensions is not possible.
Automatic operation
The device detects heat motions of people, animals and objects.
The light is switched on if a person enters the detection field and the bright-
ness threshold is below the set brightness threshold.
The run-on time restarts with each detected motion.
The light is switched off when it is no longer required because:
no more movement is detected in the detection field and the run-on time has
elapsed or the ambient light is bright enough.
The switch-off brightness is calculated from the set brightness threshold and
the connected light.
To avoid brief shading from causing switch-off, switch-off only takes place
when the set run-on time has elapsed. The run-on time does not restart on
movement detection for as long as the switch-off brightness is exceeded.
The minimum switch-off brightness is 100 lux, even if a lower value is set.
To avoid any switch-on caused by a cooling lamp, no movement signals are evalu-
ated for a brief lockout time after switching off. The motion detector adjusts itself to
the ambient conditions to keep the time as short as possible.
Short-time operation
If motion occurs, then a short pulse of approx. 0.5 seconds is triggered depending on
the brightness. The pulse is cyclically repeated as long as motions are detected.
Motion and presence detector
5 / 25
82593233 25.09.2023
J0082593233