Switch-off warning
If the switch-off warning is active, the light is not switched off immediately after the
run-on time has elapsed. Triple flashing at an interval of 10 seconds shows that the
light will be switched off soon. The run-on time is thereby prolonged by approx.
30 seconds. If movement is detected during the switch-off prewarning, then the run-
on time is restarted and the light remains on.
Dynamic run-on time
The function determines a run-on time within specified limits automatically and dy-
namically from detected movements. In so doing, the run-on time is increased if pres-
ence continues or decreased if absence is detected.
Presence simulation
In automatic operation, the motion detector continuously saves times for which the
lighting was switched on. A maximum of 60 switching operations are saved over a
period of 24 hours. If more switching operations take place, the oldest ones are over-
written respectively. If the presence simulation is activated, the motion detector
switches the lighting at the saved times depending on brightness. Switch-off takes
place after the run-on time has elapsed. Detected motions prolong the run-on time or
the light is switched on depending on brightness. Times are not saved.
Function as twilight switch
The function is active as soon as all the PIR sensors have been switched off (see
Commissioning).
The light is switched according to the brightness. Motions are not evaluated.
– The light is switched on if the brightness is below the set brightness threshold
for 4 minutes.
– The light is switched off when the switch-off brightness (see Automatic mode)
is exceeded for 4 minutes.
Switch-on and switch-off of the light via 2-wire extensions or push-buttons is
not possible. The Continuous on/off and on/off for 2 hours functions cannot be
used.
Behaviour after mains voltage return
After mains voltage return, the device performs a self-test for a maximum of
20 seconds. After the self-test has been completed, the device is ready for operation.
The device switches the light according to the settings made.
The following applies during the self-test:
– The red and blue display LEDs (4) light up.
– The device cannot be operated or set using an IR remote control.
– Movements are not detected.
– The device can be switched via 2-wire extensions or installation push-buttons.
Motion and presence detector
6 / 25
82593233 25.09.2023
J0082593233
To Next Page
Loading...