Jungheinrich EJC B14 User Manual

59
03.11 EN
8.2 CanCode keypad
CanCode keypad
The keypad consists of 10 digit keys, a Set key and a o
key.
The O key indicates the follow operating statuses via a
red / green LED:
– Code lock function (starting up the truck).
– Adjusting the travel program depending on the setting
and truck.
– Setting and changing parameters.
8.2.1 Code lock
When the correct code is entered, the truck is ready for use. You can allocate an
individual code to each truck, operator or group of operators. When originally supplied
from the factory, the code is indicated on a sticker. Change the master and operator
codes when using the truck for the first time.
Z Set different codes for rider and pedestrian trucks.
Starting the Truck
Procedure
• Switch on the Emergency Disconnect.
The LED (64) lights up red.
• Enter the code.
When you enter the correct operator
code the LED (64) turns green. If the
LED (64) flashes red this means the
wrong code has been entered. Try
again.
The truck is switched on
Z The Set key (63) has no function in operating mode.
Switching the truck off
Procedure
• Press the O key.
The truck is switched off.
Z The truck can switch off automatically after a set time. To do this the relevant code
lock parameters must be entered, (see "Parameter Settings" on page 60).
8.2.2 Parameters
The keypad enables parameters to be adjusted in programming mode.
1 2 3
4 5 6
7 8 9
0
Set
1 2 3
4 5 6
7 8 9
0
Set
63
59 60 61
62
64
59
03.11 EN
8.2 CanCode keypad
CanCode keypad
The keypad consists of 10 digit keys, a Set key and a o
key.
The O key indicates the follow operating statuses via a
red / green LED:
– Code lock function (starting up the truck).
– Adjusting the travel program depending on the setting
and truck.
– Setting and changing parameters.
8.2.1 Code lock
When the correct code is entered, the truck is ready for use. You can allocate an
individual code to each truck, operator or group of operators. When originally supplied
from the factory, the code is indicated on a sticker. Change the master and operator
codes when using the truck for the first time.
Z Set different codes for rider and pedestrian trucks.
Starting the Truck
Procedure
• Switch on the Emergency Disconnect.
The LED (64) lights up red.
• Enter the code.
When you enter the correct operator
code the LED (64) turns green. If the
LED (64) flashes red this means the
wrong code has been entered. Try
again.
The truck is switched on
Z The Set key (63) has no function in operating mode.
Switching the truck off
Procedure
• Press the O key.
The truck is switched off.
Z The truck can switch off automatically after a set time. To do this the relevant code
lock parameters must be entered, (see "Parameter Settings" on page 60).
8.2.2 Parameters
The keypad enables parameters to be adjusted in programming mode.
1 2 3
4 5 6
7 8 9
0
Set
1 2 3
4 5 6
7 8 9
0
Set
63
59 60 61
62
64

Jungheinrich EJC B14 Specifications

General

Brand	Jungheinrich
Model	EJC B14
Category	Trucks
Language	English