05.10 EN
104
6 Optional equipment
6.1 Assistance systems
The Access, Drive and Lift Control systems help the driver operate the truck with
regard to safety regulations, (see "Safety regulations for truck operation" on page 70)
" of the present operating instructions.
Travel conduct
The driver must adapt the travel speed to local conditions. The truck must be driven
at slow speed when negotiating bends or narrow passageways, when passing
through swing doors and at blind spots. The driver must always observe an adequate
braking distance between the forklift truck and the vehicle in front and must be in
control of the truck at all times. Abrupt stopping (except in emergencies), rapid U turns
and overtaking at dangerous or blind spots are not permitted. Do not lean out or reach
beyond the working and operating area.
6.1.1 Access Control
The truck is only released for operation if:
1)The driver is sitting on the seat.
2)The truck is switched on via the key switch (ISM / Can Code o).
3)He is wearing the seat belt.
Z If the driver vacates the seat for a short while and the truck is not in the "neutral
lock" position ((see "Travel" on page 78)), the truck can be operated again when he
returns (seat occupied) and puts the seat belt back on again, without having to
apply the key switch again.
Z If travel is not enabled, the seat switch indicator lights up (96). Items 1 to 3 must be
performed again in the order listed.
To Next Page
Loading...
Need help?
General
