CHAPTER 41
JPTSPD System Log Messages
This chapter describes messages with the JPTSPD prefix. They are generated by the
packet-triggered subscriber process (jptspd) which creates and manages packet-triggered
subscriber interfaces. A packet-triggered subscriber interface is created when the router
receives a packet with an IP source address that does not match any entries in the
demultiplexer table. When the router detects an unmatched packet, it generates a trigger
event that determines whether to create a dynamic subscriber interface or configure an
existing interface.
JPTSPD_INIT_FAILURE
System Log Message JPTSPD failed to initialize
Description The packet triggered subscriber process (jptspd) initialization failed.
Type Error: An error occurred
Severity error
Facility ANY
Cause One possible cause is that the system is out of memory.
Action Contact your technical support representative.
JPTSPD_OUT_OF_MEMORY
System Log Message Out of memory
Description The packet triggered subscriber process (jptspd) could not dynamically allocate memory.
Type Error: An error occurred
Severity error
Facility ANY
Cause A software bug caused a memory leak, or too many subscriber and service sessions.
Action Contact your technical support representative.
313Copyright © 2010, Juniper Networks, Inc.
To Next Page
Loading...