Juniper PTX Series - Troubleshooting the PTX5000 Pics and PIC Cables

Troubleshooting the PTX5000 PICs and PIC Cables
Problem A PIC LED lit red indicates a problem with the PIC.
Solution To troubleshoot a PIC:
1. Check the status of each port on a PIC. Look at the LEDs located on the PIC faceplate.
For information about the meaning of LED states on different PICs, see the PTX5000
Packet Transport Switch PIC Guide.
2. Check the status of a PIC, issuing the following CLI command. The PIC slots in the
FPC are numbered from 0 through 2, top to bottom:
user@host> show chassis fpc pic-status
user@host> show chassis fpc pic-status
Slot 0 Online FPC
Slot 2 Online FPC
PIC 0 Online 24x 10GE(LAN) SFP+
Slot 3 Online FPC
PIC 1 Online SNG Load
Slot 5 Online FPC
PIC 0 Online 24x 10GE(LAN) SFP+
PIC 1 Online 2x 40GE CFP
Slot 6 Online FPC
Slot 7 Online FPC
user@host> show chassis pic fpc-slot 2 pic-slot 0
FPC slot 2, PIC slot 0 information:
Type 24x 10GE(LAN) SFP+
State Online
PIC version 1.14
Uptime 3 hours, 6 minutes, 30 seconds
PIC port information:
Fiber Xcvr vendor
Port Cable type type Xcvr vendor part number
Wavelength
0 10GBASE SR MM SumitomoElectric SPP5200SR-J6-M 850
nm
1 10GBASE LR SM FINISAR CORP. FTLX1471D3BNL-J1 1310
nm
3 10GBASE LR SM FINISAR CORP. FTLX1471D3BNL-J1 1310
nm
6 10GBASE SR MM OPNEXT, INC. TRS2001EM-0014 850
nm
7 10GBASE SR MM OPNEXT, INC. TRS2001EM-0014 850
nm
10 10GBASE SR MM SumitomoElectric SPP5200SR-J6-M 850
nm
11 10GBASE SR MM FINISAR CORP. FTLX8571D3BNL-J1 850
nm
12 10GBASE SR MM SumitomoElectric SPP5200SR-J6-M 850
nm
14 10GBASE SR MM SumitomoElectric SPP5200SR-J6-M 850
nm
15 10GBASE SR MM FINISAR CORP. FTLX8571D3BNL-J1 850
nm
16 10GBASE SR MM FINISAR CORP. FTLX8571D3BNL-J1 850
147Copyright © 2012, Juniper Networks, Inc.
Chapter 14: Troubleshooting Packet Transport Switch Hardware Components