Figure 57: Instaliing the Console or Auxiliary Port Cable
2—1— Auxiliary portConsole port
Installing a Management Console or Auxiliary Port Cable
To install a management console or auxiliary device cable:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.
2. If necessary, turn off the power to the console or auxiliary device.
3. Plug one end of a copper cable with RJ-45 connectors into the CONSOLE or AUXILIARY
port on the control board in slot CB0. This port connects to the Routing Engine installed
into the control board in slot CB0.
4. Attach the other end of the cable to the console or auxiliary device.
5. Plug one end of another copper cable with RJ-45 connectors into the CONSOLE or
AUXILIARY port on CB1. This port connects to the Routing Engine installed into the
control in slot CB1.
6. Attach the other end of the cable to the console or auxiliary device.
Related
Documentation
PTX5000 Control Board Description on page 22•
• Connecting the PTX5000 Packet Transport Switch to a Management Console or
Auxiliary Device on page 86
• Preventing Electrostatic Discharge Damage to a PTX5000 Packet Transport Switch
on page 222
Replacing a PTX5000 Management Ethernet Cable
1.
Removing a PTX5000 Management Ethernet Cable on page 171
2.
Installing a PTX5000 Management Ethernet Cable on page 172
Removing a PTX5000 Management Ethernet Cable
To remove a management Ethernet cable:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.
171Copyright © 2012, Juniper Networks, Inc.
Chapter 15: Replacing Packet Transport Switch Hardware Components
To Next Page
Loading...
