Two port LEDs—labeled LINK and ACT—located below the HOST/ETHERNET port
indicate the port speed and activity.
NOTE: These ports are reserved for future use.
•
Gigabit Ethernet SFP fiber-optic or copper port— labeled GE4—located to the right of
the 10-Gigabit Ethernet ports.
NOTE: This port is reserved for future use.
Related
Documentation
PTX5000 Host Subsystem Description on page 35•
• PTX5000 Control Board LEDs on page 24
• PTX5000 Routing Engine Description on page 44
• Maintaining the PTX5000 Control Boards on page 109
• Troubleshooting the PTX5000 Control Boards on page 135
• Troubleshooting the PTX5000 Host Subsystem on page 138
PTX5000 Control Board LEDs
Three LEDs located to the left of the online/offline button indicate the status of the
control board. Table 6 on page 24 describes the functions of the control board LEDs.
Figure 13: Control Board LEDs
3—1—
LINK and ACT LEDs for the 10-Gigabit
Ethernet ports labeled (X)GE 0 (X)GE 3
MASTER, FAIL, and OK status LEDs
4—2—
LINK and ACT LEDs for the Gigabit Ethernet
port labeled GE 4
Y=10/100 G=1000 and ACT LEDs for the
HOST/ETHERNET port
Table 6: Control Board LEDs
DescriptionStateColorLabel
Control board is functioning as the master.On steadilyBlueMASTER
Control board is functioning as the backup.Off–
Copyright © 2012, Juniper Networks, Inc.24
PTX5000 Packet Transport Switch Hardware Guide
To Next Page
Loading...
