Juniper PTX10008 - Page 178

Figure 76: Right-Angle, Bare Cable with Anderson Connector
g100600
2
1
3
3—1— White wire–NeutralBlack wire–Return (+)
2—Green wire-Ground
JNP10K-PWR-DC Power Specifications
The DC power supply (JNP10K-PWR-DC) is supported in only the PTX10008 and PTX10016 redundant
configuration. Table 65 on page 180 lists the power specifications for the JNP10K-PWR-DC power supply
used in a PTX10000 chassis.
Table 65: Power Specifications for the JNP10K-PWR-DC Power Supply
SpecificationsItem
•
Minimum operating voltage: –40 VDC
•
Nominal operating voltage: –48 VDC
•
Operating voltage range: –40 VDC through –72 VDC
DC input voltage
60 A maximum at nominal operating voltage (–48 VDC) for each input
terminal
DC input current rating
2500 WOutput power
Table 66 on page 180 shows the physical specifications for a JNP10K-PWR-DC power supply.
Table 66: Physical Specifications of a JNP10K-PWR-DC Power Supply
ValueSpecification
3.5 in. (8.89 cm)Height
3.6 in. (9.14 cm)Width
180