CAUTION: The components are maximally protected inside the shipping carton. Do not
unpack them until you are ready to install the components in the router chassis.
Before you unpack a component:
•
Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD) damage.
See “Prevention of Electrostatic Discharge Damage” on page 427.
•
Ensure that you know how to handle and store the component. (See “Handling and Storing PTX10000
Line Cards, Routing and Control Boards, and SIBs” on page 321).
To unpack an RCB, a SIB, or a line card, (see Figure 79 on page 201):
1. Move the shipping carton to a staging area as close to the installation site as possible.
2. Position the carton so that the arrows are pointing up.
3. Open the top flaps on the shipping carton.
4. Pull out the packing material that holds the component in place.
5. Remove the component from the electrostatic bag.
6. Save the shipping carton and packing materials in case you need to move or ship the RCB, SIB, or line
card later.
Figure 79: Unpacking a Line Card
2—1— Paper packaging and electrostatic bagFoam packing material
201
To Next Page
Loading...
