•
If the AC or DC power source outlets have a power switch, set them to the off (O) position.
Ensure that you have the following parts and tools available to install an JNP10K-PWR-AC2 power supply:
•
Electrostatic discharge (ESD) grounding strap
•
Phillips (+) screwdriver, number 1
•
Power cables appropriate for your geographical location (for low-voltage installations) or input amperage
(for high-voltage installations). See “PTX10000 Power Cables Specifications” on page 172. HVAC and
HVDC connectors and lugs must be installed by a qualified electrician before installation.
286
To Next Page
Loading...
