Juniper SRX300 Series - LTE Mini-Physical Interface Module Hardware Specifications; LTE Mini-Physical Interface Module Installation and Configuration

NOTE: If all the LEDs are blinking, it indicates that firmware updates are in progress. Do not
power off the services gateway before the updates complete.
LTE Mini-Physical Interface Module Hardware Specifications
Table 50 on page 80 provides the hardware specifications for the LTE Mini-PIM.
Table 50: LTE Mini-PIM Hardware Specifications
ValueDescription
0.80 in. x 3.75 in. x 5.9 in.
(2.0 cm x 9.5 cm x 14.5 cm)
Dimensions (H x W x L)
0.23 lb (0.106 kg)Weight
SMAConnector type
Mini-PIMForm factor
32° F through 104° F (0° C through 40° C)Environmental operating temperature
-40° F through 158° F (-40° C through 70° C)Storage temperature
5% to 90% noncondensingRelative humidity
LTE Mini-Physical Interface Module Installation and Configuration
IN THIS SECTION
Installing the LTE Mini-PIM | 81
Configuring the LTE Mini-PIM | 85
80