CHAPTER 14
Connecting the SRX300 Services
Gateway to External Devices
•
Connecting the Dial-Up Modem to the Console Port on the SRX300 Services
Gateway on page 53
•
Connecting to the SRX300 Services Gateway CLI Using a Dial-Up Modem on page 54
Connecting the Dial-Up Modem to the Console Port on the SRX300 Services Gateway
To connect the dial-up modem to the console port on the services gateway:
1. Turn off power to the services gateway.
2. Turn off power to the modem.
3. Connect one end of the Ethernet cable supplied with your services gateway into the
console port on the services gateway.
4. Connect the other end of the CAT-5e cable (Ethernet cable) into the RJ-45 to DB-9
serial port adapter supplied with your services gateway.
5. Connect the serial port adapter to a separately purchased DB-9 female to DB-25
male adapter or other adapter appropriate for your modem.
6. Plug the modem adapter into the DB-25 connector on the modem.
7. Connect the modem to your telephone network.
8. Turn on the power to the modem.
9. Power on the services gateway by pressing the Power button on the front panel. Verify
that the PWR LED on the front panel turns green.
NOTE: Most modems have an RS-232 DB-25 connector. You must
separately purchase an adapter to connect your modem to the RJ-45 to
DB-9 adapter and the Ethernet cable supplied with the services gateway.
Related
Documentation
Connecting to the SRX300 Services Gateway CLI Using a Dial-Up Modem on page 54•
53Copyright © 2016, Juniper Networks, Inc.
To Next Page
Loading...
