Jura 761 - Preparing and Using for the First Time; Setting up the Machine; Filling the Bean Container; Determining the Water Hardness

 Preparing and using for the first time

 Preparing and using for the first time
When setting up your ENA, please note the following:
U
Place the ENA on a horizontal surface that is not sensitive to
water�
U
Choose a spot for your ENA which protects the machine
against overheating� Ensure that the ventilation slots are not
covered�
The bean container has an aroma preservation cover� This will ensure
that your coffee beans retain their aroma for longer�
Coffee beans which have been treated with additives (e�g� sugar),
ground coffee or freeze-dried coffee will damage the grinder�
T
 Only use roasted, untreated coffee beans to fill the bean
container�
T
 Remove the aroma preservation cover�
T
 Remove any dirt or foreign objects from inside the bean
container�
T
 Fill the bean container with coffee beans and close the aroma
preservation cover�
When you use the machine for the first time, you must set the water
hardness� If you do not know the hardness of your water, you can
find this out first� Use the Aquadur® test strips supplied with the
machine�
T
 Hold the test strip under flowing water for one second� Shake
off the water�
T
 Wait for about 1minute�
T
 You will then be able to read the degree of water hardness from
the discolouration of the Aquadur® test strip and the descrip-
tion on the packaging�
Setting up the machine
Filling the bean container
CAUTION
Determining the water
hardness