Jura 761 - Permanently Setting the Amount of Water for the Cup Size; Adjusting the Grinder

 Preparation

It is easy to make permanent settings for the amount of water for all
speciality coffees according to the cup size� Adjust the amount once
as shown in the following example� Every time you prepare a drink
in the future, this amount of water will be dispensed�
The process for permanently adapting the amount of water to the
cup size is the same for all speciality coffees�
Example:Proceed as follows to permanently set the amount of
water for one coffee�
T
 Place a cup under the coffee spout�
T
 Press the o button for about  seconds.
The coffee flows into the cup�
T
 Press any button as soon as there is sufficient coffee in the cup�
Preparation stops� The set amount of water for one coffee is
permanently stored�
E You can alter this setting at any time by repeating the above
procedure�
You can adjust the grinder to suit the degree of roast of your coffee�
If you adjust the consistency of grind when the grinder is not
operating, the grinding wheel could be damaged�
T
 Only adjust the consistency of grind when the grinder is
running�
E The consistency of grind is correct if the coffee flows
regularly from the coffee spout� In addition a fine, thick
crema forms�
Grinding wheel
U
1: Coarse consistency of grind setting
U
2: Fine consistency of grind setting
Example:Proceed as follows to change the consistency of grind
during the preparation of an espresso�
T
 Place a cup under the coffee spout�
T
 Press the i button�
T
 Turn the grinder adjustment wheel to the desired position while
the grinder is running�
The preset amount of water flows into the cup�
Permanently setting the
amount of water for the cup
size
Adjusting the grinder
CAUTION
1
2