Jura D60 - Setting Cup Size Water Amount; Adjusting the Coffee Grinder

17
2 Preparation
It is easy to make permanent settings for the amount of water for all
speciality coffees according to the cup size. Adjust the amount once
as shown in the following example. Every time you prepare a drink
in the future, this amount of water will be dispensed.
The process for permanently adapting the amount of water to the
cup size is the same for all speciality coffees.
Example:Proceed as follows to permanently set the amount of
water for one coffee.
Precondition:
CAPPUCC. is displayed (example).
T Place a cup under the coffee spout.
T Turn the Rotary Switch until
COFFEE is displayed.
T Press and hold the Rotary Switch, until
ENOUGH
COFFEE? appears.
T Release the Rotary Switch.
Preparation starts and the coffee flows into the cup.
T As soon as there is sufficient coffee in the cup, press the
Rotary Switch.
Preparation stops.
OK appears briefly on the display. The set
amount of water for one coffee is permanently stored.
COFFEE appears on the display.
E You can alter this setting at any time by repeating the above
procedure.
E You can also permanently set the amount of water for all spe-
ciality coffees in programming mode (see Chapter 4 ‘Perma-
nent settings in programming mode – Product settings’).
You can adjust the grinder to suit the degree of roast of your coffee.
If you adjust the consistency of grind when the grinder is not oper-
ating, the grinder adjustment switch could be damaged.
T Only adjust the consistency of grind when the grinder is run-
ning.
The consistency of grind is correct if the coffee flows regularly from
the coffee spout. In addition a fine, thick crema forms.
Permanently setting the
amount of water for the
cup size
Adjusting the grinder
CAUTION