Jura D60 - Unit for Amount of Water; Language

25
4 Permanent settings in programming mode
T Touch the P symbol to exit programming mode.
CAPPUCC. (example)
In the programme item
UNITS you can set the unit used for the
amount of water.
Example:Proceed as follows to change the unit for the amount of
water from
ML to OZ.
Precondition:
CAPPUCC. is displayed (example).
T Touch the P symbol for approximately 2 seconds until
RINSE appears on the display.
T Turn the Rotary Switch until
UNITS is displayed.
T Press the Rotary Switch to enter the programme item.
ML
T Turn the Rotary Switch until OZ is displayed.
T Press the Rotary Switch to confirm the setting.
OK appears briefly on the display.
UNITS
T Touch the P symbol to exit programming mode.
CAPPUCC. (example)
In the programme item
LANGUAGE you can set the language
used by your D6.
Example:Proceed as follows to change the language from
EN to
DE.
Precondition:
CAPPUCC. is displayed (example).
T Touch the P symbol for approximately 2 seconds until
RINSE appears on the display.
T Turn the Rotary Switch until
LANGUAGE is displayed.
T Press the Rotary Switch to enter the programme item.
EN
T Turn the Rotary Switch until DE is displayed.
T Press the Rotary Switch to confirm the setting.
OK appears briefly on the display.
SPRACHE
T Touch the P symbol to exit programming mode.
CAPPUCC. (example)
Unit for amount of water
Language