Jura D60 - Machine Maintenance Procedures; Rinsing the Fine Foam Frother; Daily Cleaning of the Fine Foam Frother

26
5 Maintenance
5 Maintenance
Your D6 has the following integrated maintenance programmes:
U
Cleaning the fine foam frother (M-CLEAN)
U
Cleaning the machine (CLEAN)
U
Descaling the machine (DESCALE)
E Proceed with the maintenance programmes when prompted
to do so.
E You can start the maintenance programmes at any time in
programming mode (programme item
RINSE).
Ten minutes after milk preparation, the D6 prompts you to perform
milk system rinsing.
Precondition:
M-RINSE/ CAPPUCC. is displayed (example).
T Place a receptacle under the fine foam frother.
T Touch the Maintenance symbol c for approximately
2 seconds until
OPEN SWITCH appears.
T Turn the switch to them position.
The fine foam frother is rinsed.
CLOSE SWITCH
T Turn the switch to the °position.
CAPPUCC. (example)
To ensure that the fine foam frother always works properly, you
must clean it daily when you have been preparing milk
If the wrong cleaning agent is used, the machine could be damaged
and/or traces could be left behind in the water.
T Use only original JURA maintenance products.
E JURA milk system cleaner is available from specialised dealers.
Precondition:
CAPPUCC. is displayed (example).
T Touch the P symbol for approximately 2 seconds until
RINSE appears on the display.
T Press the Rotary Switch to enter the programme item.
M-RINSE
Rinsing the fine foam
frother
Cleaning the fine foam
frother
CAUTION