Jura E80 - Setting the Water Hardness; Milk System Rinsing

26
4 Permanent settings in programming mode
The harder the water is, the more frequently the E8 needs to be
descaled. It is therefore important to set the water hardness
accurately.
The water hardness was set when the machine was first used. You
can change this setting at any time.
The water hardness can be adjusted on a continuous scale between
1 °dH and 30 °dH.
T Press the ‘Pc’ button.
T Press the ‘>’ button several times until ‘5/5’ is displayed.
T Press the ‘Water hardness’ button.
‘Water hardness’
T Press the ‘<’ or ‘>’ button to change the setting for the
water hardness.
T Press the ‘Save’ button.
‘Saved’ appears briefly on the display.
‘5/5’
T Press the ‘’ button to exit programming mode.
In the program item ‘4/5’ / ‘Rinse the milk system’ you can make the
following settings:
U
‘Manual’: You are prompted to perform milk system rinsing
10minutes after preparation of a specialty coffee with milk.
U
‘Automatic’: The milk system rinsing is automatically initiated
10minutes after preparation of a specialty coffee with milk.
Example:Proceed as follows to set the milk system rinsing to be
initiated automatically 10 minutes after the preparation.
T Press the ‘Pc’ button.
T Press the ‘>’ button several times until ‘4/5’ is displayed.
T Press the ‘Rinse the milk system’ button.
‘Rinse the milk system’
T Press the ‘Automatic’ button.
T Press the ‘Save’ button.
‘Saved’ appears briefly on the display.
‘4/5’
T Press the ‘’ button to exit programming mode.
Setting the water
hardness
Milk system rinsing