Permanent settings in programming mode
The harder the water is, the more frequently the ENA needs to be
descaled� It is therefore important to set the water hardness accu-
rately�
The water hardness was set when the machine was first used� You
can change this setting at any time�
The number of symbols that are brightly lit up indicates the set
water hardness level:
Water hardness Symbol(s) shown in display
1–7°dH
s
8–15°dH
ss
16–23°dH
sss
24–30°dH
sss £
T
Press the f button�
The & symbol lights up brightly�
T
Press the o button several times until the u symbol lights up
brightly�
T
Press the s button to enter the programme item�
T
Press the i/o button to change the setting for the water
hardness�
Press the s button to confirm the setting�
E The setting must be confirmed within 20 seconds�
The sss£ symbols flash 3 times in quick succession�
Setting the water hardness
To Next Page
Loading...
