Jura ENA 9 One Touch - Switching Off and Rinsing; Programming Mode: Custom Settings; Product Settings (Strength, Amount); Milk Specialty Customization

17
4 Permanent settings in programming mode
pt
es
nl
en
fr
ru
en
de
T Rinse the water tank with clean water.
T Dismantle and rinse the dual spout (see
Chapter 5 ‘Maintenance – Dismantling and
rinsing the dual spout’).
T Wipe the surface of the machine with a clean,
soft, damp cloth (e.g. microfiber cloth).
Switching off the machine
When the ENA is switched off, the system is
automatically rinsed if a specialty coffee has been
prepared. If cappuccino or latte macchiato has
been prepared, the cappuccino rinse also takes
place.
T Place a receptacle under the dual spout.
Q T Press the On/Off button.
RINSING, CAPPUCCINO
RINSING, the system rinses itself,
stopping automatically. The ENA is switched
off.
E When the ENA is switched off with the On/
Off button, the machine does not consume
standby energy.
4 Permanent settings in pro-
gramming mode
Products
In the program item PRODUCT you can make
individual settings for all specialty coffees and milk
specialties.
J WARNING
Hot coffee, hot steam and hot water can cause
scalding. Scalding is a serious burn.
T Use extreme care when handling hot liquid
or steam.
T Allow liquid to cool down before drinking.
T In the event of scalding, rinse affected area
with cold water and seek medical attention.
T Keep children AWAY.
You can make the following permanent settings for
the specialty coffees:
U
Amount of water: 0.5OZ – 8.0OZ
(25 ml – 240ml) (per cup)
U
Coffee strength (for 1 coffee): MILD,
NORMAL, STRONG
U
Temperature: NORMAL, HIGH
(approx. 176–205 °F (80–96 °C))
You can make the following permanent settings for
latte macchiato and cappuccino:
U
Amount of milk foam: 3SEC – 120SEC
U
Interval: 0SEC – 60SEC
U
Coffee strength: MILD, NORMAL, STRONG
U
Amount of water: 0.5OZ – 8.0OZ
(25 ml – 240ml)
U
Temperature: NORMAL, HIGH
(approx. 176–205 °F (80–96 °C))
Permanent settings in programming mode always
follow the same model.
Example: Permanently change the coffee strength
(
FLAVOUR) for 1 coffee from NORMAL to
STRONG.
Precondition:
READY is displayed.
k T Press and hold the Rotary Switch until
RINSE appears.
g T Turn the Rotary Switch until
PRODUCT is
displayed.
k T Press the Rotary Switch to enter the
program item.
SELECT BUTTON
E Next select the button of the product for
which you would like to make settings. No
product is prepared at this point.
E To change the setting for a double product,
press the corresponding button twice within
two seconds.
> T Press the Coffee button.
1COFFEE
WATER
g T Turn the Rotary Switch until FLAVOUR is
displayed.