Jura ENA Micro 1 - Grinder Adjustment; Filling the Water Tank; Determining Water Hardness

Elektroapparate AG
Disassembling manual
Technical Support
Language
EN
ENA Micro line / IMPRESSA A line
Author: Patrik Studer
Checked:
Approved:
Docu.-name: Demontage_ENA_Micro_EN.docx
L:\Geräte\Linie_A\A5_OT\Schulungsunterlagen\E\Demontag
e_ENA_Micro_EN.docx
Date:
Rev. G:
Rev. B:
Rev. C:
Rev. D:
Rev. E:
Rev. F:
06.10.2011
20.02.2014
21.03.2012
19.09.2012
14.11.2012
27.03.2013
17.09.2013
Page 12/26
41. Pull down carefully the snap-lock of the multi-
valve support and remove the multi-valve
42. Pull out the pump of the pump support
43. Pull with a small screw driver into the slot to
release the lateral interlock and remove it
44. Remove the transformer
45. Variation when print and pump is removed:
Release snap-lock of the tank base.
46. Turn at the same time the tank base
(bayonet lock).