15
ENA 3
de
fr
it
en
it
Example: Changing the water hardness from
16°dH to 25°dH.
Precondition: READY appears on the display.
Open the cover behind the Rotary Switch.
P T Press the P button until MAINTENANCE
appears.
g T Turn the Rotary Switch until HARDNESS
is displayed.
k T Press the Rotary Switch to enter the
programme item.
16°dH
g T Turn the Rotary Switch until 25°dH is
displayed.
k T Press the Rotary Switch to confirm the
setting.
OK, the water hardness is then adjusted.
HARDNESS
g T Turn the Rotary Switch until EXIT is
displayed.
k T Press the Rotary Switch to exit program-
ming mode.
READY
Adjusting grinder
You can adjust the grinder continuously to suit
the roast of your coffee.
CAUTION
If you adjust the fineness of grind when the
grinder is not operating, the grinding wheel could
be damaged.
Only adjust the fineness of grind when the
grinder is running.
The fineness of grind setting is correct if the
coffee flows regularly from the coffee spout.
A fine, thick crema is also formed.
Our recommendations:
Select a fine setting for a light roast.
T
T
Z
If the fineness of grind setting is too fine,
the coffee only drips from the coffee spout.
Select a coarse setting for a darker roast.
If the fineness of grind is too coarse the
coffee flows too quickly from the coffee
spout.
Example: Adjusting the fineness of grind during
coffee preparation.
Place the cup under the coffee spout.
k T Press the Rotary Switch to start coffee
preparation.
Turn the fineness of the grinding wheel to
the desired position while the grinder is
running.
1 CUP, the pre-set amount of water flows
into the cup, preparation stops automati-
cally.
READY
U
Z
U
T
T
To Next Page
Loading...
