18
ENA 3
One-off setting before and during
preparation
The coffee strength can be changed before
preparation or during the grinding operation.
The following coffee strength options are possible
for 1 coffee:
Mild
Normal
Strong
2 coffees are always prepared with the
coffee strength ‘mild’.
The pre-set amount of water can be
changed during the brewing operation by
turning the Rotary Switch.
One-off settings before and during coffee
preparation always follow this model. These
settings are not saved.
Example: Changing the coffee strength of
1 coffee before preparation from
NORMAL
to
STRONG.
Precondition:
READY is shown on the display.
Place the cup under the coffee spout.
g T Turn the Rotary Switch until STRONG is
displayed.
k T Press the Rotary Switch until STRONG is
displayed.
During grinding the coffee strength
STRONG is displayed.
1 CUP, the pre-set amount of water
flows into the cup, preparation stops
automatically.
READY
Entering a default setting for the amount of
water for a cup size
A default setting can be entered for the
amount of water for 1 coffee. When
preparing 2 coffees this amount is
dispensed per cup.
Z
Z
Z
E
E
T
E
Precondition:
READY is shown on the display.
Place the cup under the coffee spout.
k T Press the Rotary Switch and hold it down.
During grinding the strength of the coffee
is displayed.
k T Continue to hold the Rotary Switch down
until
ENOUGH COFFEE ? appears.
The coffee flows into the cup.
k T Press the Rotary Switch again when enough
coffee has been filled into the cup.
OK, the default setting for the amount of
water for one coffee has been entered.
READY
This setting can be changed at any time by
repeating the above procedure.
Cappuccino with the
Professional Cappuccino Frother
Precondition: READY is shown on the display.
Remove the protective cover from the
Professional Cappuccino Frother.
Connect the milk pipe to the nozzle.
Insert the other end of the milk pipe into a
milk carton or connect it to a milk
container.
Place a cup under the nozzle.
Set the selector lever of the nozzle to the
milk foam
p position.
g T Turn the Rotary Switch until STEAM is
displayed.
k T Press the Rotary Switch.
HEATING
READY appears as soon as the ENA is
sufficiently heated.
T
E
T
T
T
T
T
To Next Page
Loading...
