Jura ENA3 - Machine Maintenance; Daily Care and Manual Rinsing

24
ENA 3
4 Maintenance
The ENA has the following integrated mainte-
nance programmes:
Rinse machine
Change filter
Clean machine
Descale machine
Clean or descale the machine or change the
filter whenever the appropriate indicator
lights up.
Maintenance tips
To ensure a long service life and the best possible
coffee quality, the ENA requires the following daily
care:
Empty the coffee grounds container and drip
tray and rinse with warm water.
Rinse the water tank with clean water.
Wipe the surface of the machine with a damp
cloth.
Rinse the nozzle regularly if it is used to warm
or froth milk.
Rinsing the machine – manually
When the ENA is switched on, a prompt to
perform a rinse operation automatically appears
after heating. When the ENA is switched off, the
system is automatically rinsed if a coffee speciality
has been prepared.
The ‘Rinse machine’ operation can be manually
initiated.
Precondition:
READY appears on the display.
Place a receptacle under the coffee spout.
Open the cover behind the Rotary Switch.
P T Press the P button until MAINTENANCE
appears.
k T Press the Rotary Switch to enter the
programme item.
RINSE
Z
Z
Z
Z
E
Z
Z
Z
Z
T
T
k T
Press the Rotary Switch to start rinsing.
RINSING, rinsing stops automatically.
READY
Changing the filter following a prompt
After 50 litres of water have flowed through
the filter, its capacity is reached. The ENA
automatically prompts you to replace the
filter.
After two months the filter capacity is
reached. The elapsed time can be checked
with the date plate on the cartridge holder.
If the CLARIS plus filter cartridge is not
activated, you will not be prompted to
change the filter.
Precondition:
READY / FILTER is displayed.
Open the cover behind the Rotary Switch.
c T Press the maintenance button.
INSERT FILTER
Remove and empty the water tank.
Open the cartridge holder and remove the
old filter cartridge.
Insert the filter cartridge into the water
tank, exerting slight pressure.
Close the cartridge holder. It will click into
place audibly.
Fill the water tank with cold, fresh water
and replace the tank.
Place a receptacle (at least 500 ml) under
the nozzle.
k T Press the Rotary Switch.
OPEN TAP
E
E
E
T
T
T
T
T
T
T