Jura ENA3 - Machine Maintenance; Manual Cleaning and Descaling

26
ENA 3
Close the powder chute for pre-ground
coffee.
PRESS ROTARY
k T Press the Rotary Switch.
CLEANING, water flows out of the
coffee spout several times.
EMPTY TRAY
Empty the coffee grounds container and
drip tray and replace.
READY
Cleaning the machine – manually
The ‘Clean machine’ operation can be manually
initiated.
Precondition:
READY appears on the display.
Open the cover behind the Rotary Switch.
P T Press the P button until MAINTENANCE
appears.
k T Press the Rotary Switch to enter the
programme item.
RINSE
g T Turn the Rotary Switch until CLEAN is
displayed.
k T Press the Rotary Switch.
EMPTY TRAY
Continue with the third prompt to take
action (indicated by
T), as described in the
section ‘Cleaning the machine following
a prompt’.
T
T
T
T
Descaling the machine following a prompt
The ENA builds up limescale deposits over time
and automatically prompts you to descale the
machine when necessary. The degree of build-up
depends on the hardness of the water.
CAUTION
If the descaling agent comes into contact with the
skin or eyes, this can cause irritation.
Avoid contact with the skin or eyes.
Rinse the descaling agent off with clean
water. Should you get any descaling agent
in your eye, consult a doctor.
CAUTION
Risk of damage to the machine and residues in
the water if the wrong descaling agent is used.
Only use original JURA care products.
CAUTION
Risk of damage to the machine if the descaling
operation is interrupted.
Do not interrupt the descaling operation.
CAUTION
Risk of damage if the descaling agent comes into
contact with sensitive surfaces.
Remove splashes immediately.
The descaling programme lasts approx.
40 minutes.
JURA descaling tablets are available from
stockists.
If a CLARIS plus filter cartridge is used
and activated, you will not be prompted
to descale the machine.
Precondition:
DE-SCALE / READY is
displayed.
Open the cover behind the Rotary Switch.
c T Press the maintenance button.
EMPTY TRAY
J
T
T
T
T
T
E
E
E
T