30
ENA 3
g T Turn the Rotary Switch until STEAM is
displayed.
k T Press the Rotary Switch.
HEATING
READY
appears as soon as the ENA is
sufficiently heated.
l T Turn the switch to position m.
STEAM, the nozzle and pipe are cleaned.
y T Turn the switch clockwise to position o as
soon as the receptacle holding the Auto-
Cappuc cino Cleaner is empty.
Rinse the receptacle thoroughly, fill with
250 ml of fresh water and immerse the milk
pipe in the water.
Empty the receptacle under the nozzle and
replace under the nozzle.
g T Turn the Rotary Switch until STEAM is
displayed.
k T Press the Rotary Switch.
HEATING
READY appears as soon as the ENA is
sufficiently heated.
l T Turn the switch to position m.
STEAM, the nozzle and pipe are rinsed
with fresh water.
y T Turn the switch clockwise to position o
as soon as the receptacle holding
the water is empty.
Dismantling and rinsing the
Easy Cappuccino Frother
Carefully remove the Easy Cappuccino
Frother from the Connector System
©
.
Dismantle the nozzle completely.
T
T
T
T
Rinse all nozzle parts thoroughly with
running water.
Reassemble the Easy Cappuccino Frother
and attach it to the Connector System
©
.
Dismantling and rinsing the 2-stage frothing
nozzle
To ensure that the 2-stage frothing nozzle
functions correctly, clean it regularly if you have
heated or frothed milk.
CAUTION
Danger of burns from the hot nozzle and nozzle
connector.
Wait until the nozzle has cooled before
cleaning.
Carefully remove the nozzle from the
Connector System
©
.
Unscrew the nozzle using the hole on the
measuring spoon for pre-ground coffee.
Rinse all three nozzle parts thoroughly
under running water.
Reassemble the nozzle and attach it to the
Connector System
©
.
T
T
J
T
T
T
T
T
To Next Page
Loading...
