Jura GIGA X8c - Determining Water Hardness; Connecting the Milk System

15
1 Preparing and using for the first time
You can also obtain the following optional accessories for your GIGA
from your JURA service partner:
U
Set for automatic discharging of coffee grounds
You can find out what the water hardness is by using the Aquadur®
test strip supplied as standard.
T Hold the test strip briefly (for 1second) under flowing water.
Shake off the water.
T Wait for about 1minute.
T You will then be able to read the degree of water hardness
from the discolouration of the Aquadur® test strip and the
description on the packaging.
Your GIGA creates fine, creamy, feather-light milk foam with a per-
fect consistency. The most important requirement for frothing milk
is a milk temperature of 4–8°C. We would therefore recommend
using a milk cooler (e.g. the JURA Compressor Cooler Pro, which is
available as an option).
T Connect the milk pipe to the dual spout.To do this, attach
the end of the milk pipe to the connector on the right-hand
side of the dual spout.
T Connect the other end of the milk pipe to a milk cooler.
Determining the water
hardness
Connecting milk