Jura GIGA X8c - Setting Grind Consistency

30
4 Permanent settings in programming mode
Example:Proceed as follows to display the product ‘2 espressi’ in the
bottom right-hand corner of the start screen.
Precondition:
‘Please select product:’ is displayed.
 O T Press the P button.
‘Maintenance status (1/5)’
 g T Turn the Rotary Switch until the programme item ‘Product
settings (2/5)’
is displayed.
T Press the
‘Classics’ button.
‘Classics’
E Next select the button of the product you want to move to the
start screen. No product is prepared at this point.
T Press the
‘2 espressi’ button.
‘2 espressi’
T Press the ‘Save’ button.
T Press the
‘Add to favourites’ button.
‘Select position’
T Press the button at the bottom right (‘Latte macchiato’)
‘Do you want to replace the current product?’
T Press the ‘Yes’ button.
‘Saved’ appears briefly on the display.
‘Classics’
 O T Press the P button to exit programming mode.
‘Please select product:’
In the programme item ‘Product settings (2/5)’/ ‘Set consistency of
grind’
you can adjust both grinders separately to the degree of roast
of your coffee.
The consistency of grind is correct if the coffee flows regularly from
the dual spout. In addition a fine, thick crema forms.
Example:Proceed as follows to change the consistency of grind for
the grinder on the right.
Precondition:
‘Please select product:’ is displayed.
 O T Press the P button.
‘Maintenance status (1/5)’
 g T Turn the Rotary Switch until the programme item ‘Product
settings (2/5)’
is displayed.
Setting the consistency
of grind