Jura GIGA6 - Page 26

26
4 Permanent settings in programming mode
Product Amount More settings
‘Latte
macchiato’
Water: 25ml–240ml
Milk foam:
0sec.–120sec.
Milk: 0sec.–120sec.
Interval: 0sec.–60sec.
Coffee strength (10 levels), milk and milk foam
temperature, temperature (low, normal, high), left
and/or right grinder (in %), product name, delete/
replace/copy/double product
‘Macchiato’ Water: 15ml–80ml
Milk foam:
0sec.–120sec.
Coffee strength (10 levels), milk foam temperature,
temperature (low, normal, high), left and/or right
grinder (in %), product name, delete/replace/copy/
double product
‘Flat White’,
‘Caffè latte’
Water: 25ml–240ml
Milk foam:
0sec.–120sec.
Milk: 0sec.–120sec.
Coffee strength (10 levels), milk and milk foam
temperature, temperature (low, normal, high), left
and/or right grinder (in %), product name, delete/
replace/copy/double product
‘Portion milk’,
‘Portion milk
foam’
Milk foam:
0sec.–120sec.
Milk: 0sec.–120sec.
Milk and milk foam temperature, product name,
delete/replace/copy/double product
‘Hot water’,
‘Hot water for
green tea’
Water: 25ml–450ml Temperature (low, normal, high), product name,
delete/replace/copy product
Double
products
The amounts set for
the single product are
doubled.
Temperature (as for single product), left and/or right
grinder (in %), product name, delete/replace/copy
product
Permanent settings in programming mode always follow the same
model.
Example:Proceed as follows to change the coffee strength for one
espresso.
Precondition:The start screen is displayed.
T Touch ‘Espresso’ for approximately 2 seconds until the list
of possible settings is displayed.
T Touch
‘Product settings’.
‘Espresso’
T Move your finger across the display until ‘Coffee strength’ is
displayed in the centre.
T Now move your finger to the left or right to change the set-
ting for the coffee strength.