Jura IMPRESSA A5 One Touch - Control Elements Overview

Elektroapparate AG
Technical information
Technical Support
Language
EN
IMPRESSA A5 One Touch
Author: Patrik Studer
Checked:
Approved:
Docu.-name:
Technische_Informationen_IMPRESSA_A5_OT_EN.doc
L:\Geräte\Linie_A\A5_OT\Schulungsunterlagen\E\Technisch
e_Informationen_IMPRESSA_A5_OT_EN.doc
Date:
Rev. A:
Rev. B:
Rev. C:
Rev. D:
Rev. E:
Rev. F:
24.09.2013
20.02.2014
Page 4/10
1.1 Service connector:
To release the service-cover you can follow up the steps below (analogue to ENA Micro GII):
 Insert a metal ruler (thickness max. 0.5 mm) on the front side and slide it to the left
(pay attention to not scratch the control panel)
 New:
Unlock tool for service cover ENA Micro Art. No. 71178
 Support this action by pushing with finger from above
 Release the left lock analogue the right
2 Key combinations:
2.1 Reset to “first use” (Language, Fill system, Initializing):
 Appliance is ready for coffee
 Empty system according to (chapter 21)
 Switch on appliance
 Do not set the filter and continue until the message FILL SYSTEM is shown on the display
 Push the button ROTARY SWITCH & ESPRESSO simultaneously until the message OK
shows up
 Switch off appliance
2.2 Read out software version:
 Appliance is switched on
 Open powder chute
 Push the button ROTARY SWITCH & MAINTENANCE simultaneously until the message OK
shows up
(SW-Version Main, Loader-Version Main, Machine number, Serial number Main, Production date
UCHI Main)