Jura IMPRESSA A5 One Touch - Programming Mode Settings

45
4 Permanent settings in programming mode
pt
es
nl
it
fr
ru
en
de
T Place a receptacle under the dual spout.
Q T Press the On/Off button.
RINSING, CAPPUCCINO
RINSING, the system rinses itself. The
operation stops automatically. Your
IMPRESSA is switched off.
E When the IMPRESSA is switched off with the
On/Off button, the machine does not
consume standby energy.
4 Permanent settings in pro-
gramming mode
Products
You can make the following permanent settings for
espresso and coffee:
U
Amount of water: 25ML – 240ML
U
Coffee strength: NORMAL, STRONG
U
Temperature: NORMAL, HIGH
You can make the following permanent settings for
latte macchiato and cappuccino:
U
Amount of milk foam: 3SEC – 120SEC
U
Interval: 0SEC – 60SEC
U
Coffee strength: NORMAL, STRONG
U
Amount of water: 25ML – 240ML
U
Temperature: NORMAL, HIGH
You can make the following permanent setting for
hot water:
U
Amount of water: 25ML – 450ML
Permanent settings in programming mode always
follow the same model.
Example:Permanently change the coffee strength
(
FLAVOUR) for espresso from STRONG to
NORMAL.
Precondition:
READY is displayed.
k T Press and hold the Rotary Switch until
RINSE appears.
g T Turn the Rotary Switch until
PRODUCT is
displayed.
k T Press the Rotary Switch to enter the
programme item.
SELECT BUTTON
E Next select the button of the product for
which you would like to make settings. No
product is prepared at this point.
< T Press the Espresso button.
ESPRESSO
WATER
g T Turn the Rotary Switch until FLAVOUR is
displayed.
k T Press the Rotary Switch to enter the
programme item.
STRONG
g T Turn the Rotary Switch until NORMAL is
displayed.
k T Press the Rotary Switch to confirm the
setting.
OK, the coffee strength is set.
FLAVOUR
g T Turn the Rotary Switch until EXIT is
displayed.
k T Press the Rotary Switch to exit the pro-
gramme item.
PRODUCT
g T Turn the Rotary Switch until EXIT is
displayed.
k T Press the Rotary Switch to exit programming
mode.
READY
Setting the water hardness
E If you are using the CLARIS Blue filter
cartridge and have activated it in program-
ming mode, you will not be able to adjust
the water hardness.
The harder the water is, the more frequently the
IMPRESSA needs to be descaled. It is therefore
important to set the water hardness accurately.
The water hardness can be adjusted on a continu-
ous scale between 1° dH and 30° dH.