Jura IMPRESSA A9 One Touch - Setting the Water Hardness; Automatic Switch-Off; Unit for Amount of Water

20
4 Permanent settings in programming mode
U
‘Start screen’ / ‘Inactive’
U
The start screen is deactivated. The product
selector view is displayed as standard.
Example:Proceed as follows to deactivate the start
screen.
Precondition:The start screen is displayed.
T Touch the Menu symbol t for about
2 seconds.
T Touch ‘>’ (bottom right) several times
until the program item ‘Start screen’ is
displayed.
T Touch ‘Start screen’.
‘Start screen’ / ‘Active’
T Touch ‘Inactive’.
T Touch ‘Save’.
‘Saved’ appears briefly on the display.
T Touch the Menu symbol t to exit program-
ming mode.
The product selector view is displayed.
Setting the water hardness
E If you are using the CLEARYL Blue filter
cartridge and have activated it, it is not
possible to set the water hardness.
The harder the water is, the more frequently the
IMPRESSA needs to be descaled. It is therefore
important to set the water hardness accurately.
The water hardness can be adjusted on a continu-
ous scale between 1 °dH and 30 °dH.
Precondition:The start screen is displayed.
T Touch the Menu symbol t for about
2 seconds.
T Touch ‘>’ (bottom right).
T Touch ‘>’ several times until ‘Water
hardness’ is displayed.
T Touch ‘Water hardness’.
‘Water hardness’
T Touch ‘<’ or ‘>’ to adjust the water
hardness.
T Touch ‘Save’.
‘Saved’ appears briefly on the display.
T Touch the Menu symbol t to exit program-
ming mode.
The start screen is displayed.
Automatic switch-off
By instructing your IMPRESSA to automatically
switch itself off, you can cut down your energy
consumption. Your IMPRESSA switches off
automatically after the preset time following the
last action on the machine.
You can set the automatic switch-off to 15minutes,
30minutes or 1–15hours.
Precondition:The start screen is displayed.
T Touch the Menu symbol t for about
2 seconds.
T Touch ‘>’ (bottom right).
T Touch ‘>’ several times until ‘Switch off
after’ is displayed.
T Touch ‘Switch off after’.
‘Switch off after’
T Touch ‘<’ or ‘>’ to change the setting.
T Touch ‘Save’.
‘Saved’ appears briefly on the display.
T Touch the Menu symbol t to exit program-
ming mode.
The start screen is displayed.
Unit for amount of water
You can change the unit for the amount of water
from ‘ml’ to ‘oz’.
Precondition:The start screen is displayed.
T Touch the Menu symbol t for about
2 seconds.
T Touch ‘>’ (bottom right).
T Touch ‘>’ several times until ‘Units’ is
displayed.
T Touch ‘Units’.
‘Units’
T Touch ‘ml’ or ‘oz’ to select the unit for the
amount of water.