Jura IMPRESSA C5 - Adjusting Default Cup Size

23
3 Familiarising yourself with the control options
m l Press the Rotary Switch to initiate preparation of the
coffee.
The grinder starts up, the 1 coffee symbol
d fl ashes,
and one light segment above the Rotary Switch is illu-
minated.
ä l While the grinder is running, turn the Rotary Switch in a
clockwise direction until three light segments have lit up.
The grinding operation stops, brewing begins and the pre-
defi ned quantity of water fl ows into the cup.
Drink preparation stops automatically.
It is easy to adjust the amount of water for all coffee specialities
to the cup size for good. As in the following example, adjust the
amount of water once. Every time you prepare a drink in the
future, this amount of water will be dispensed.
Permanent adjustment of cup size works the same way for all
coffee specialities.
Example: To permanently adjust the amount of water for an
Espresso, you should proceed as follows:
Place an Espresso cup under the coffee spout.
ä l Turn the Rotary Switch to the 1 Espresso setting a.
m l Keep the Rotary Switch pressed down until the light
segment fl ashes above the Rotary Switch.
Coffee preparation will start and the Espresso will fl ow
into the cup.
m l Press the Rotary Switch again when enough Espresso
has fl own into the cup.
Espresso preparation will now stop. Your IMPRESSA
will remember the amount of water you have specifi ed
for an Espresso for good.
You can alter these settings at any time by repeating the
above procedure.
l
o
Adjusting the default
cup size settings
Adjusting the default
cup size settings