40
8 Maintenance
Once the IMPRESSA has heated up following switch-on,
the Maintenance symbol
h will light up, prompting you to
perform a rinse operation. To initiate the rinse operation,
press the Rotary Switch.
When the IMPRESSA is switched off, a rinse operation is
automatically performed.
Precondition: the IMPRESSA is ready for use.
Place a receptacle under the coffee spout.
ä l Turn the Rotary Switch so that it points to the Maintenance
symbol
h .
m l Press the Rotary Switch to start the rinse operation.
The rinse operation now starts and the Maintenance
symbol
h fl ashes.
Rinsing stops automatically.
Your IMPRESSA is ready for use.
After 50 litres of water have been dispensed, the fi lter will
cease to work. Your IMPRESSA will automatically prompt
you to replace the fi lter.
After two months, the fi lter will cease to work. Monitor the
elapsed time as shown on the date plate on the cartridge
holder.
If the CLARIS plus fi lter cartridge is not activated, you
will not be prompted to change the fi lter.
To change the CLARIS plus fi lter cartridge when prompted to do
so by your IMPRESSA, you should proceed as follows:
Precondition: the Maintenance indicator and the Filter
indicator
n are illuminated.
Remove the water tank and empty it.
o
o
l
o
o
o
l
Rinsing the machine Rinsing the machine
Changing the fi lter Changing the fi lter
Replacement following a
prompt
Replacement following a
prompt
To Next Page
Loading...
