41
8 Maintenance
Lift the cartridge holder.
Take out the old CLARIS plus fi lter cartridge.
Insert the new CLARIS plus fi lter cartridge into the wa-
ter tank, pressing it lightly.
Close the cartridge holder.
It will lock into place audibly.
Fill the water tank with cold, fresh mains water and
reinsert.
Place a receptacle (containing at least 500 ml) under
the Easy-Auto-Cappuccino Frother.
If the milk pipe is connected, remove it.
n l Hold down the Filter button until the Filter indicator n
fl ashes.
The light segment by the switch will now fl ash.
r l Turn the switch in the anticlockwise direction.
Rinsing of the fi lter will now begin. The light segment by
the switch will now light up.
The water could be slightly discoloured. This is not harmful to
health, nor does it affect the taste.
Rinsing of the fi lter will automatically stop after approx.
500 ml, and the light segment by the switch will then
fl ash.
t l Turn the switch in the clockwise direction.
The Maintenance symbol
h fl ashes, the IMPRESSA
heats up and is once again ready for use.
You can initiate the 'Changing the fi lter' operation manually.
Start when the fi rst prompt appears
l, as described under
'Replacement following a prompt'.
After dispensing 200 cups of coffee or performing 80 switch-on
rinses, the IMPRESSA will prompt you to clean it.
If the wrong cleaning agent is used, the machine could be dam-
aged and/or traces of detergent could be left behind in the water.
Use only original JURA care products.
l
l
l
l
l
l
l
l
Manual fi lter changeManual fi lter change
Cleaning the machine Cleaning the machine
CAUTIONCAUTION
To Next Page
Loading...
