43
8 Maintenance
Empty the drip tray and the coffee grounds container.
Insert the empty drip tray and coffee grounds container
back in the machine.
The cleaning operation is now complete. The Maintenance
symbol
h fl ashes, the IMPRESSA heats up and is once
again ready for use.
You can initiate the 'Cleaning the machine' operation manually.
Start when the fi rst prompt appears
l, as described under 'Clean-
ing following a prompt'.
The IMPRESSA builds up deposits of limescale over time and
automatically prompts you to descale it when necessary. The
degree of calcifi cation depends on the degree of hardness of your
water.
If the descaling agent comes into contact with the skin or eyes,
this can cause irritation.
Avoid contact with the skin or eyes.
Rinse the descaling agent off with clean water. Should you
get any descaling agent in your eye, see a doctor.
If the wrong descaling agent is used, the machine could be
damaged and/or traces of detergent could be left behind in the
water.
Use only original JURA care products.
If the descaling operation is interrupted, it is possible that the
machine could be damaged.
Allow the descaling program to run to the end.
If the descaling agent comes into contact with sensitive surfaces,
the possibility of damage cannot be excluded.
Clean up any splashes immediately.
The descaling program lasts approx. 40 minutes.
Your dealer will stock JURA descaling tablets.
l
l
l
l
l
l
l
o
o
Manual cleaningManual cleaning
Descaling the machine Descaling the machine
CAUTIONCAUTION
CAUTIONCAUTION
CAUTIONCAUTION
CAUTIONCAUTION
To Next Page
Loading...
