Jura IMPRESSA C9 - Filter Rinsing; Filter Change

3
IMPRESSA C9 – Quick Reference Guide
T Lift the cartridge holder and insert the filter cartridge into
the water tank, applying slight pressure.
T Close the cartridge holder. It will click into place audibly.
T Fill the water tank with fresh, cold water and reinsert.
T Place a receptacle (at least 500 ml) under the frother.
c T Press the maintenance button.
FILTER RINSING. Water will flow out of the frother.
E You can interrupt rinsing of the filter at any time by pressing
any button.
E The water may be slightly discoloured. This is not harmful to
health and does not affect the taste.
Filter rinsing stops automatically after approx. 500 ml.
HEATING appears on the display, then READY is dis-
played. The filter is now activated.
E After 50 litres of water have flowed through, or after two
months, the filter will cease to work. Your IMPRESSA will auto-
matically prompt you to change the filter.
E If the CLARIS filter cartridge is not activated, you will not be
prompted to change the filter.
To change the CLARIS filter cartridge when prompted to do so by
your IMPRESSA, proceed as follows:
Precondition:
READY / FILTER is displayed and the mainte-
nance button c lights up.
c T Press the maintenance button.
CHANGE
T Remove the water tank and empty it.
T Open up the cartridge holder and remove the old CLARIS fil-
ter cartridge.
Filter change