Jura IMPRESSA F7 - Milk Foam

17
2 Preparation
 * T Press the Cappuccino button.
NORMAL
HEATING/ STEAM
As soon as the machine has heated up, SWITCH OPEN
appears.
The arrow on the switch lights up.
 j T Turn the switch to them position.
CAPPUCCINO, the milk foam is prepared. Preparation
stops automatically when the preset amount of steam is
reached.
SWITCH CLOSE
 h T Turn the switch to the °position.
The illuminated arrow on the switch goes out.
CAPPUCCINO appears on the display.
Coffee preparation starts. The preset amount of water for
espresso flows into the cup.
Preparation stops automatically.
READY appears on the
display.
To ensure that the fine foam frother always works properly, you must
clean it daily when you have been preparing milk (see Chapter 5
‘Maintenance – Cleaning the fine foam frother’). Your IMPRESSA will
not prompt you to clean the fine foam frother.
E This chapter applies to the professional fine foam frother and
the fine foam frother.
E With the professional fine foam frother, available as an
optional accessory, you can also prepare hot milk.
Example:Proceed as follows to prepare milk foam.
Precondition:
READY is displayed.
T Remove the protective cover from the fine foam frother.
T Connect the milk pipe to the fine foam frother. Use the short
pipe for a milk container and the long pipe for a milk carton.
T Connect the other end of the milk pipe to a milk container
or immerse it in a milk carton.
Milk foam